Up one level (MICOR index) Back to Home |
Ordering instructions for rebuilt MICOR receiver preselector castings or complete receiver conversions for the 2 meter ham band. |
The right coils are available,
at the right price!
Why are we offering replica preselector coil replacements?
Replica Coils placed into your MICOR front-end
casting:
I can install replica 132 - 150.8 MHz resonator coils into your casting and return it to you.
How much, and what do I need to do?
Send me just the casting with original coils intact and prepayment - US$45.00
to the address below. I will recoil your preselector with replica 132 - 150.8 MHz
resonator coils and return it to you. Price includes return shipping in the US via USPS Priority.
Please allow three to four weeks from the time you send me the casting until you receive it back.
This allows a week each way in shipping and a week here in the shop for modification.
** No junk please, send the factory original casting with unmodified coils
and cover intact for conversion. **
The 12 screws that hold the casting to the receiver circuit board DO NOT need to be sent.
Complete MICOR receiver
conversion available:
I offer complete receiver conversion for either the 150.8 - 162 or 162 - 174 MHz
MICOR high-band receiver to 2 meter ham band (142 - 150.8 MHz.)
Modification of your preselector and high-band receiver RF - I-F board to properly tune the
2 meter ham band is $85.00 per receiver. Price includes return shipping in the US via
USPS Priority. Conversion includes changing all necessary parts
on the circuit board itself and helical resonator modification as suggested
above. The modification insures that a High-Side injection crystal
will properly work throughout the local oscillator chain as intended by
the factory for the 142 - 150.8 split receivers.
So, how do I get the complete receiver conversion
with replica preselector coils?
Send US$85.00
prepayment with your receiver to the address below.
** No junk please **, send factory original receiver board with unmodified
casting and all screws intact for conversion. Please allow three to four weeks from
the time you send me the receiver until you receive it back. This allows a week each
way in shipping and a week or so here in the shop for modification. Receivers are
tested prior to and after conversion to verify performance.
Price includes return shipping in the US via USPS Priority.
See shipping address below for sending your receiver and payment to me for conversion.
Conversions are done following the information that can be seen here.
If you are outside the Continental United States, or require other than
USPS shipping, e-mail for
a quote on shipping and handling charges.
Terms are prepayment US funds, sorry if that is not acceptable.
NO Personal Checks Accepted! US Funds Only.
Send equipment and payment by Bank Cashiers Check or US Money Order Only to:
Kevin Custer
6 Canarsie Place
Palm Coast FL 32137
Back to the top of the page
Up one level (MICOR index)
Back to Home
This page originally posted on 12-15-2008
Last edited 5/24/2024
This web page, this web site, the information presented in and on its pages and in these modifications and conversions is © Copyrighted 1995 and (date of last update) by Kevin Custer W3KKC and multiple originating authors. All Rights Reserved, including that of paper and web publication elsewhere.